Failed to read a VW Simos 2 ECU with foxflash. Error SK2 and seed key. Any solution? IECUTOOL.EU Solution: The voltage is low. Raise voltage to 13V+. And better read on bench instead of full system. Foxflash VAG Simos 3.xx ECU bench pinout
Foxflash new user report: Today work Ford Fiesta ST 1.5 Eco boost 2022 ECU Bosch MG1CS016 Bench Read ok. Bench write ok. Checksum by foxflash Voltage 13.5V Stage 1 ok. OBD not recommended Bench is safe. www.iecutool.eu
Problem: Is it possible to perform an ADBLUE OFF on a Peugeot 208 from 12/2020 in 1.5 HDi with a bosh MD1CS003 engine calculator with Foxflash? Answer: No tool will read MD1 ecu after 2020/06. 037 hardware locked… not possible with any tool. www.iecutool.eu
FormulaFlash programmer new user feedback: Renault Bosch EDC16C36 ECU Read on bench ok Write on bench ok Checksum by tool.
Alientech KESS3 new user report: New Holland Model: T4 2021 Version T4.65 3.4L ECU Bosch MD1CS069 Protocol 1678 Read on bench Write on bench Checksum by kess3. Need truck/agricultural machinery license activated. www.iecutool.eu
Foxflash tech released an offline dongle for Foxflash to work without network connection. How to get the offline dongle for Foxflash? 1: Only old customers can get foxflash dongle 2: If an old customer successfully introduces a new customer order Foxflash, he or she can receive a dongle for free. 3: Get the dongle for… Read More »
Foxflash new user report: Dacia Sid306 only works boot. Full read for clone. Using sid305 tc1766 protocol type 1. Sid306 not listed in app but same processor. Read ok Write ok Checksum with foxflash. All good www.iecutool.eu
When reading your remap with foxflash programmer via obd2 (i.e DCM6.2V) and this error pops out ERROR SEED-KEY what does it actually mean? Its pretuned and seedkey changed so cant work via obd. Well basically its saying that someones allready been on there. It prevents obd2 read/write, so only way is to bench or bdm… Read More »
Foxflash new user report: Got a new work table and power source, first test with new setup. Audi A6 C7 3.0tdi 160kW ECU EDC17CP54 Read ok on bench Write ok bench Checksum by tool. Adblue off. No problems, all good. You reset all adblue related stuff with diagnostic software. (I used launch) Then removed ecu… Read More »
Problem: Problem reading JTAG on Citroen DCM3.5, foxflash reported “Error OSR”; What is the solution? Solution: Double check wiring diagram. Or try to reverse the jtag rainbow cable. This is the way how the customer did it.
